The newer version was slightly bigger at 241 Mib. The installer returned Zoom 5.15.6, so I updated. I then used the AppImage Installer to check for an update. The initial version installed was Zoom 5.13.11, so a slightly older version. The Zoom Appimage that was initially installed weighed in at a slim 237 MiB, about 10% of the flatpak. Yesterday I did a new manual install to another card to see a comparison with the Zoom Appimage using the Appimage Installer. The installation was 2,420 MiB( 2.36 GiB), which was a surprise.

I was somewhat aware that this would occur, due to the nature of flatpak isolation from the installed distribution.

I did notice that lots of extra packages were also being installed.

All went well and zoom worked without issue. This is the first time I've tried flatpak The install went well and installed Zoom 5.15.2, so very current. Tut-one-not-working.FCStd no grid showing (5.Last week after installing EasyOS 5.4.5, I needed to install Zoom, so it was a good chance to try the flatpak installer. I have attached my 'this is as far as I got' test file. I have less than zero interest in upgrading to a higher version of Windows - this was just an experiment to see it the behavior differed. I got the message: 'The program can't start because api-ms-win-crt-runtime-l1-1-0.dll is missing from your computer.' Despite support being ended for Win7 I attempted to run the update so install that dll, and after that FreeCAD did at least start, but immediately crashed. I have not tried the Appimage)Īs an experiment, I did try booting my Windows system and downloading FreeCAD 0.20 to try to run that, but my Windows is Win7. I installed from the version that was current and supplied with the version of Debian I am running (11). When I download and open test.FCStd it does not show a grid.īelieve I originally said that I downloaded 0.19 - not quite true.

Zoom 5.15.6 for windows instal